New ✔️ Tribord Offshore Race 900, Sailing Jacket, Men’s 🌟

Waterproof and breathable!

—specs—

WATERPROOFING

– Three-layer hydrophilic membrane fabric
– >28,000 mm water pressure.
– Fully taped seams.
– Two-way adjustable hood with semi-rigid visor and drainage channel.
– Synthetic rubber sleeve cuffs adjustable by rip-tab strips.
– Adjustable synthetic rubber neck.
– Adjustable neoprene waist for a perfect fit with salopettes
– Tested under a simulated heavy rain shower (450 L/hr/sqm) for 24 hours

BREATHABILITY

RET <15: breathable.

To find out whether a fabric is breathable, we measure its evaporative resistance, or RET, (test based on the ISO 11092 standard). It is its ability to allow the water vapour produced by the body during exercise to escape.

COMFORT

– 21 cm fleece collar (back)
– Weight: 1110 g in size L
– Fleece hand pockets
– Compartmented front pocket for a knife or VHF

REFLECTIVE

– 2 shoulder patches
– 2 hood patches
intensifying sources of low light

RESISTANCE TO WEAR

– Injected plastic central zip resistant to salt oxidation.- Coating to prevent oxidation, which impairs membranes

HOW TO REACTIVE THE JACKET’S WATER REPELLENCYnstep 1: before washing

Close all zips and flaps and remove any parts of the garment that cannot be washed. Also remember to loosen the straps and elastic parts and empty the pockets.
Then turn the garment inside out to wash it.

HOW TO REACTIVE THE JACKET’S WATER REPELLENCYnstep 2: washing

You can wash your jacket on a synthetic cycle at 30° or 40°C with your usual detergent. Do not use fabric conditioner, which could damage the existing performance of the garment, or bleach.

Also take care not to bend your jacket too much when you place it in the washing machine and do not overload your machine.

Very important: select a thorough rinse or double rinse to completely remove all detergent residue.

HOW TO REACTIVE THE JACKET’S WATER REPELLENCYnstep 3: drying

Drying is a crucial phase in reactivating the water repellent treatment.
We recommend that you lay your jacket flat on a clothes rack and leave it out to dry in the open. Caution: never dry your jacket directly on a radiator.

Then place it in the tumble dryer on a short synthetics cycle, i.e. 10 to 15 minutes, before turning it back the right way round. Caution: do not over-dry the garment.

HOW TO REACTIVE THE JACKET’S WATER REPELLENCY

If, despite this procedure of washing and thorough rinsing followed by gentle drying in a tumble dryer, the drops of water no longer run off the surface of your jacket, we recommend that you “re-waterproof” it using a spray sold in our stores.

SCORE TO COMPARE THE ENVIRONMENTAL IMPACT OF PRODUCTS

The environmental impact of the product is calculated over its entire life cycle and with different indicators.
An overall score (ABCDE) is attributed to help you easily identify the products with the best environmental performance by comparing products of the same type with one another (T-shirts, trousers, backpacks, etc.).
Decathlon chose to apply this voluntary environmental labelling scheme.
Explanatory video: https://youtu.be/8t63KkRwn_8
sustainability.decathlon.com

Composition

Main fabric : 100.0% Polyamide (PA)rnWaist band : 100.0% Rubber – Chloroprene (CR) – NeoprenernHood : 100.0% Polyester (PES)rnLining : 100.0% Polyester (PES)rnYoke : 76.0% Polyester (PES), Yoke : 24.0% Elastane

Storage Instructions

Store in a dry place, but do not leave your garment on a heat source such as a radiator, as this may damage the breathable coating.

Guarantee

2 Years

—/specs—

—catchline—

Breathable waterproof jacket that is perfect for all of your more “athletic” sailing trips. Its neoprene waistband, double collar and cuffs act as seals, keeping out water.

—/catchline—

—features—

—/features—

—made_for—

yacht racers looking for maximum protection from the elements.

—/made_for—