Outlet ❤️ Tribord 500, Waterproof Sailing Yacht Racing Overalls, Men’s 😀

These salopettes, especially designed to provide protection, are waterproof and breathable. Zipped fleece-lined pockets will be a shelter for your hands.

These overalls were designed by our sailing team to protect you from the elements of sea and heavy rain during training as well as during regattas.

WATERPROOFING

– Membraned 2-layer fabric
– A strong rain corresponds to a flow of 100 L/m2/h – (= rainfall of 100 mm/h)
– The rainfall simulator reproduces these conditions for 3 hours.
– Component resistant to water pressure of 5000 mm after aging = 5000 Schmerber – average pressure of water during a downpour

– Water-repellent components allow water to runs off the fabric.
– 100% taped seams.
– Central opening features a flap with a drainage channel for optimal waterproofing

BREATHABILITY

RET <12: very breathable.

To find out whether a fabric is breathable, we measure its evaporative resistance, or RET, (test based on the ISO 11092 standard). It is its ability to allow the water vapor produced by the body during exercise to escape.

COMFORT

The waist is adjustable using semi-elasticated rip-tabs.

REFLECTIVE

A large reflective 3M patch on the back intensifies low light sources. The Tribord logos are also reflective.

RESISTANCE TO WEAR

Injected plastic central zipper resistant to salt oxidation.

HOW TO REACTIVATE THE JACKET’S WATER-REPELLENCY
step 1: before washing

Close all zippers and flaps and remove any parts of the garment that cannot be washed. Also remember to loosen the straps and elastic parts and empty the pockets.
Then turn the garment inside out to wash it.

HOW TO REACTIVATE THE JACKET’S WATER-REPELLENCY
step 2: washing

You can wash your jacket on a synthetic cycle at 86°F or 104°F with your usual detergent. Do not use fabric softener, which could damage the existing performance of the garment, or bleach.

Also take care not to bend your jacket too much when you place it in the washing machine and do not overload your machine.

Very important: select a thorough rinse or double rinse to completely remove all detergent residue.

HOW TO REACTIVATE THE JACKET’S WATER-REPELLENCY
step 3: drying

Drying is a crucial phase in reactivating the water-repellent treatment.
We recommend that you lay your jacket flat on a clothes rack and leave it out to dry in the open. Caution: never dry your jacket directly on a radiator.

Then place it in the tumble dryer on a short synthetics cycle, i.e. 10 to 15 minutes, before turning it back the right way around.

HOW TO REACTIVATE THE JACKET’S WATER-REPELLENCY

If, despite this procedure of washing and thorough rinsing followed by gentle drying in a tumble dryer, the drops of water no longer run off the surface of your jacket, we recommend that you “re-waterproof” it using a spray sold in our stores.

Composition

Main fabric : 100.0% Polyamide
Main lining : 100.0% Polyester cationic
Secondary lining : 100.0% Polyamide
Yoke : 100.0% Polyester cationic

Care Instructions

Machine wash your Offshoroa waterproof and breathable salopettes at 86°F. Inside-out with hook and loop strips stuck together. Choose a long rinse and gentle spin cycle. Line dry if possible. Occasional tumble drying on low for a short period of time will improve the water-repellent treatment. To reactivate the water-repellent treatment, you can also iron the fabric at a maximum temperature of 284°F or apply the Tribord re-waterproofing spray.

Waterproof : Approved in a simulator reproducing HEAVY RAIN conditions

Breathability : Very breathable (RET<12).

Salt water resistant : Injected plastic zipper.

Pockets : 3 secure pockets (2 fleece, 1 on the thigh).

Abrasion resistant : Seat, knee and ankle reinforcements to resist wear.

Easy to use : Adjustable ankles, high cut for better waterproofness.